Actis Venous Flow Controller
Instructions

1. To stretch the ACTIS device: Grasp the loop of ACTIS with the left hand. Note that the end of the tubing with the ball is on top (Figure 1).

With the right hand, grasp the loop next to the O ring and stretch the ACTIS device(Figure 2).

2. To place around the shaft of the penis: Place the end of the penis through the stretched loop and slide ACTIS over the shaft of the penis (Figure 3) until it is around the base (see Figure 5).

3. To place ACTIS: Place ACTIS so that the loop goes around the base of the penis. The part of the tubing with the ball should be on the top side of the penis. Grasp the tab end (lower end) of the tubing without the ball. Pull horizontally away from the penis until ACTIS is gently snug around the base of the penis (Figure 4).

When ACTIS is first put in place, the ends of the tubing should be on either side of the shaft of the penis with the ball on top (Figure 5).

4. To get proper tension: Grasp the tab on the end of the tubing without the ball and pull down (Figure 6). ACTIS should be tight enough to keep the blood from leaving the penis. Too much tension may stop the erection process. Too much tension may lead to discomfort and could cause harm to the penis.

If the erection is not firm enough, apply pressure with your hand to the area behind the scrotum. This may push more blood into the penis. As the penis becomes firm, ACTIS may be tightened or loosened to get an erection while providing the most comfort.

5. To loosen the tension: After intercourse or if the erection is too firm, ACTIS may be loosened by pulling up on the end of the tubing with the ball (Figure 7). Once fully loose, ACTIS can be removed by sliding the loop over the end of the penis.

CARE AND REPLACEMENT OF THE ACTIS ADJUSTABLE CONSTRICTION LOOP

Care of ACTIS: If you use a lubricant for sexual activity, use only water-based lubricants. Oil-based lubricants may decrease the performance of ACTIS.
ACTIS can be used more than once. Clean after use with warm water and ordinary hand soap. Keep ACTIS dry and store it at room temperature after it is cleaned.

Replacement: Repeated use of the ACTIS device may result in wearing out of the latex loop. Replace ACTIS after 6 months of use or when it shows signs of wear such as cracking.